Archive for April, 2008

Fyola Facial Massager - Step by Step - Instructions

1. Apply gel or quality lotion

Apply a suitable amount of water soluble gel or lotion (a circle with 2 cm diameter) on the facial head or your skin. Gel is better, since it doesn’t dry up quickly on your skin and increases the conduction of ultrasound waves. Aloe Vera gel seems to have good results.

2. Switch the power ON

Press on the power button to turn the Fyola on. The Fyola face massager send out a beep sound and some of the green or red light will turn on or flashing

3. Choose the Right mode

C: Cleansing (apply ultrasound gel)
M:Massaging (apply ultrasound gel)
N: Nutrition (apply quality lotion or serum)
L :Lifting (apply quality lotion or serum)

Optional Modes
W: Whitening (apply whitening lotion or serum)
W: Wrinkle Care (apply anti-aging lotion or serum)

You can use the two basic steps (good for acne skin) in a row:

1. Cleansing (4 minutes)

2. Massaging (4 minutes)

Total basic treatment is only 8 minutes.

A. Apply gel –> Choose Cleansing Mode –> Select Ultrasound mode –> Gently rub your whole face for 4 minutes –> Wash your face with warm wet towel

B. Apply gel –> Choose Massaging Mode –> Select Ultrasound mode –> Gently rub your whole face for 4 minutes –> Wash your face with warm wet towel

C. Done

4 Ultrasonic, Galvanic Ion or Both?

For massage and cleansing mode select ultrasonic wave mode is enough. This will remove waste inside your skin. Especially good for acne or oily skin.

When choosing lifting, nutrition, whitening or wrinkle care mode choose galvanic ion mode to enhance the absorption of cosmetic ingredients (Vitamin C) into your skin. For best results select both the ulrasound and ion mode. When both the ultrasonic and galvanic ion mode are used at the same time, the permission through the out skin layer will be 77 times better than using the ultrasonic mode or galvanic mode separately.

5. Move the facial head around your face
Move the treatment head of the facial massager in circle following the formation of the muscles. See illustrations for the directions. Do not stop moving the treatment head in use, about the rate of 5 centimeters within 1 second. The power will shut off automatically.

Click here to read more instruction how to use the Fyola face massager

Comments (10)

LED Photon Facial Massager - Does it really work?

What is LED Skin Rejuvenation?

LED Skin Rejuvenation is the interaction of light, delivered through Light Emitting Diodes (LEDs), to activate cell receptors causing them to produce collagen or multiply.

How does LED Skin Rejuvenation work?

The light from the LEDs interacts with cells and stimulates them to produce new collagen and elastin. By manipulating the wavelengths, cells can be turned on and off. Yellow light LEDs are used for photo-rejuvenation. Blue light LEDs are used in the treatment of acne. Red light LEDs are used for PhotoDynamic therapy.

Does LED Skin Rejuvenation work?

So far, no scientific studies has shown that LED will renew your skin.

Comments